Although many users now use thresher equipment, how much do you know about the scientific use of equipment? Today, Aike uses a Top Quality Model 125 Large Rice And Wheat Threshergive you a brief introduction.
- Inspection before the trial operation 1 Check that the bearing of each part and the high-speed rotating parts on the shaft are installed properly. 2 Check the tension of the V-belt and the chain. 3 Check if any tools or extraneous items remain on the working parts of the harvester and all the covers are in place. 4 Check if fuel, oil, and lubricating oil are in place. 2, no-load test run 1-star engine clutch, shift lever in neutral position. 2 Start the engine and engage the clutch at low speed. When all working parts and various mechanisms are functioning properly, gradually increase the engine speed, always to the rated speed, and then operate the harvester at the rated speed. 3 During operation, the following checks are carried out: the hydraulic cylinders of the hydraulic system are sequentially activated to check the working conditions of the hydraulic system, the sealing of the hydraulic pipelines and the hydraulic components, and the braking of the harvester (driving). After every 20 minutes of operation, the engine clutch is scattered once to check whether the bearing is overheated and the transmission of the belt and chain, and the fastening of each joint. When all the gears are used to join the working parts in sequence, the harvester is commissioned and the parts are carefully detailed during operation. The corn harvester has an air test time of not less than 3 hours, and the flight test time is not less than 1 hour.
- Operational test run: Within 30 hours of the initial work, it is recommended that the speed of the harvester be 20% to 25% lower than the normal speed. The normal working speed can be carried out according to the working speed recommended by the manual. After the test run, thoroughly check the degree of device fastening of each component, the accuracy of assembly adjustment, and the working condition of electrical equipment. Replace all gear units and close the gearbox lubricant.
- Careful matters when working 1 rice and wheat thresher should be smoothly combined with the clutch of the working part before the operation, the throttle can be started from the small to large, and the stable rated speed can be started. When working in the field of 2 rice and wheat thresher, it is necessary to regularly check the quality of cutting and smashing and the height of stubble, and adjust the height of the header at any time according to the situation. 3 Check the work of picking the ear according to the number of seeds thrown to the ground. The loss of grain should not exceed 0.5% of the total grain of wheat and wheat. When the loss is large, check whether the working gap between the picking boards is accurate. 4 The corn harvester should be properly stopped for 1 minute to 2 minutes to allow the working parts to run empty, so as to remove all residues of rice and wheat ears, grains, etc. from the working parts, and the working parts are not allowed to be blocked. When the working parts are clogged, stop the blockage in time, otherwise, the friction between the rice and wheat thresher will increase and the parts will be damaged. 5 When the rice and wheat thresher turns or encounters water hoes along the corn row, the header should be raised to the transport position. When working in a field with a ditch, the corn harvester can only work along the ditch.
